Salifert Nitrate profi NO3 test
Price:
€13.90
Tax included
Salifert Nitrate NO3 Profi Test is a rapid colour-comparison test for measuring nitrate in marine and freshwater aquariums. Its total measurement range extends from approximately 0.2 to 100 mg/l NO₃, with a separate low-range reading method for concentrations below 10 mg/l. Depending on the product version and test conditions, the kit provides approximately 50–60 measurements.
The Salifert Nitrate Profi Test uses two powdered reagents to produce a colour reaction proportional to the nitrate concentration. The developed colour is compared with the included chart.
Two reading methods provide a broad working range:
- Low range: 0.2–10 mg/l NO₃
- Medium range: 2–100 mg/l NO₃
The low-range method is particularly useful in reef aquariums, while the medium range is suitable for fish-only marine systems and freshwater aquariums.
Key features
- Measures nitrate as NO₃
- Total range approximately 0.2–100 mg/l
- Low range 0.2–10 mg/l
- Medium range 2–100 mg/l
- Suitable for marine aquariums
- Suitable for reef aquariums
- Suitable for freshwater aquariums
- Two colour-chart reading methods
- Reaction time approximately three minutes
- Formulated to reduce amine interference
- Suitable for low-nutrient systems
- Also measures elevated nitrate concentrations
- No electronic meter or batteries required
- Approximately 50–60 tests, depending on product version
Technical information
- Product: Salifert Nitrate NO3 Profi Test
- Test type: colour-comparison powder-reagent test
- Parameter: nitrate NO₃
- Units: mg/l or ppm NO₃
- Total range: approximately 0.2–100 mg/l
- Low range: 0.2–10 mg/l
- Medium range: 2–100 mg/l
- Sample volume: 1 ml
- Reaction time: approximately three minutes
- Suitable water: marine and freshwater
- Electronic meter required: no
Directions
- Rinse the test vial with the water to be tested.
- Add 1 ml of aquarium water.
- Add one level scoop of NO3-1 powder.
- Add one level scoop of NO3-2 powder.
- Swirl gently for 30 seconds—do not shake.
- Allow the sample to stand for three minutes.
- For the medium range, place the vial on the white section of the chart and compare the colour from above.
- If the result is below 10 mg/l, read the sample through the side of the vial.
- Hold the white section of the chart against the opposite side.
- Divide the side-view chart value by ten.
- Record the result and rinse the vial and scoop after use.
(muokkaa moduulissa Asiakkaan vakuuttaminen)
Fast shipping
Warranty quaranteed
12 other products in the same category
Hanna Reagents for phosphorus ULR 0 to 200 ug / l 25 pcs
€17.90
Rated out of 5 stars based on
review(s)
Comments (0)
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent