Glamorca Sediment Filter

The Glamorca Sediment Filter captures suspended particles from incoming tap water. Removing these contaminants before the carbon filters and membrane reduces clogging and helps the complete RO/DI system maintain consistent performance.

The cartridge has a nominal filtration rating of 5 microns and is designed specifically for the twist-lock cartridge system used in the Glamorca RO1.

Key features

• Original Glamorca replacement cartridge
• Designed for the Glamorca RO1
• First filtration stage
• Nominal filtration rating: 5 microns
• Removes sand, silt, dirt and rust
• Protects the activated-carbon cartridges
• Helps protect the RO membrane
• Supports consistent flow and water production
• Quick twist-lock replacement
• Product code: LS-SF
• Typical replacement interval: approximately 3–6 months
• Glamorca’s general RO1 recommendation: approximately every 4 months
• Intended for aquarium-water preparation
• Not washable or reusable

Technical information

• Product: Glamorca Sediment Filter
• Type: replacement sediment cartridge
• Compatibility: Glamorca RO1
• Filtration stage: 1
• Nominal rating: 5 microns
• Maximum flow: approximately 1 GPM
• Operating temperature: approximately 5–52 °C
• Operating pressure: approximately 2–5.5 bar
• Product code: LS-SF

Replacement

1. Close the feed-water valve.
2. Disconnect the RO1 from power.
3. Release internal pressure according to the system manual.
4. Unlock and remove the old sediment cartridge.
5. Install the new LS-SF cartridge in the correct position.
6. Turn the cartridge until fully locked.
7. Open the feed water slowly.
8. Check carefully for leaks.
9. Flush the new cartridge according to the operating instructions.
10. Discard the initial flushing water.
11. Confirm normal flow and product-water TDS.
12. Reset the filter indicator where required.