Glamorca RO1 Activated Carbon Filter

The activated-carbon cartridge forms part of the Glamorca RO1 pre-filtration system. It treats water after sediment filtration and before the later carbon, membrane and deionisation stages.

The porous activated carbon adsorbs chemicals that are not removed by a mechanical sediment filter. Its most important function is reducing chlorine and organic contaminants that could damage the thin separation layer of the RO membrane.

Key features

• Original Glamorca replacement cartridge
• Designed for the Glamorca RO1
• Contains activated carbon
• Reduces chlorine
• Reduces volatile organic compounds
• Reduces pesticides and herbicides
• Reduces other adsorbable chemicals
• Helps reduce unwanted odour and colour
• Protects the RO membrane from chemical damage
• Supports consistent membrane rejection
• Helps extend membrane and DI-cartridge life
• Enclosed quick-change cartridge
• Twist-lock installation
• Typical replacement interval: approximately six months
• Not washable or reusable
• Intended for aquarium-water preparation
• Product code: LS-ACF [korallifarmi.fi], [whitecorals.com]

Activated carbon versus carbon block

The Glamorca RO1 uses two separate carbon cartridges:

• Activated Carbon Filter, LS-ACF: removes VOCs, pesticides, herbicides, chlorine and other harmful chemicals.
• Activated Carbon Block Filter, LS-CBF: provides a second carbon stage that further reduces chlorine and organic contaminants before the membrane.

Always confirm the cartridge code and installation position before replacement. [sewatec.com], [akvareef.lt], [whitecorals.com]

Replacement

1. Close the feed-water valve.
2. Disconnect the RO1 from power.
3. Release internal pressure according to the manual.
4. Unlock and remove the old activated-carbon cartridge.
5. Confirm that the replacement is model LS-ACF.
6. Install it in the correct filter position.
7. Turn the cartridge until fully locked.
8. Open the feed water slowly.
9. Check carefully for leaks.
10. Flush the new cartridge according to the system instructions.
11. Discard the initial flushing water.
12. Confirm normal flow and product-water TDS.
13. Reset the filter-service indicator when required.