Salifert Silicate profi test
Price:
€13.90
Tax included
Salifert Silicate Profi Test is a sensitive colour-comparison test for measuring silicate in marine and freshwater aquariums, tap water and purified source water. It helps identify silicate entering through tap water or an underperforming RO/DI system, where it may support diatom growth. The test covers approximately 0.03–30 mg/l as SiO₂ and provides around 60 measurements.
The test uses two liquid reagents and one powdered reagent to produce a colour proportional to the dissolved silicate concentration. Low concentrations are read through the side of the vial, while higher concentrations can be measured by viewing the sample from above and multiplying the chart result by five.
The test is suitable for checking aquarium water, tap water, reverse-osmosis water, deionised water and newly mixed saltwater.
Key features
- Sensitive silicate test
- Reports results as SiO₂
- Approximate range: 0.03–30 mg/l
- Suitable for marine aquariums
- Suitable for reef aquariums
- Suitable for freshwater aquariums
- Suitable for tap and RO/DI water
- Helps investigate persistent diatom growth
- Useful for monitoring RO membranes and DI resin
- Low-range side-view reading
- Extended-range top-view reading
- Approximately 60 tests
- No electronic meter or batteries required
- EAN: 8714079130439
Technical information
- Product: Salifert Silicate Profi Test
- Test type: colour-comparison silicate test
- Reported compound: silicon dioxide, SiO₂
- Units: mg/l or ppm
- Approximate range: 0.03–30 mg/l
- Sample volume: 1 ml
- Initial reaction time: 5 minutes
- Second reaction time: 1 minute
- Final mixing time: 20 seconds
- Number of tests: approximately 60
- Water types: marine and freshwater
- Electronic meter required: no
Directions
- Add 1 ml of the water sample to the test vial.
- Add four drops of Si-1.
- Swirl gently for ten seconds.
- Allow the sample to stand for five minutes.
- Add four drops of Si-2.
- Swirl gently for ten seconds.
- Allow the sample to stand for one minute.
- Add one level scoop of Si-3 powder.
- Swirl gently for 20 seconds.
- For low concentrations, compare the colour through the side of the vial.
- Hold the white section of the colour chart against the opposite side.
- For higher concentrations, place the vial on the white section and view it from above.
- Multiply a top-view result by five.
- Rinse all test equipment thoroughly after use.
(muokkaa moduulissa Asiakkaan vakuuttaminen)
Fast shipping
Warranty quaranteed
12 other products in the same category
Hanna pH-electrode Quick DIN connection for HI98190 & HI991001
€309.90
Rated out of 5 stars based on
review(s)
Tropic Marin Compact Lab Test Set contains: pH, KH, PO4,NO2, NO3, NH3,
€84.90
Rated out of 5 stars based on
review(s)
Hanna Reagents for Nitrite LR - 0.00 to 0.35 mg / L - ± 100 tests
€94.90
Rated out of 5 stars based on
review(s)
Comments (0)
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent