Chihiros RGB Vivid ja WRGB2 -kiinnike

The stand provides a ceiling-free suspension solution for compatible Chihiros RGB Vivid and WRGB II lights. Two aluminium supports attach to the rear aquarium glass, and the light is suspended between them with suitable hanging cables.

The mounting height can be adjusted according to the aquarium dimensions, plant requirements, and desired light spread. The Small stand provides an approximate height range of 30–40 cm, while the Regular version provides approximately 42–52 cm.

Key features

• Two-stand mounting system for Chihiros lights
• Suitable for RGB Vivid and WRGB II series
• Attaches to the rear aquarium glass
• Requires no ceiling drilling
• Frees the aquarium side and front rims
• Improves maintenance access
• Adjustable lighting height
• Available in Small and Regular versions
• Small height range: approximately 30–40 cm
• Regular height range: approximately 42–52 cm
• Manufactured from aluminium alloy
• Black finish
• Suitable for open and rimless aquariums
• Suitable for glass up to approximately 20 mm, depending on version
• Two stands included
• Aquarium and LED light sold separately

Package contents

• Two aluminium lighting stands
• Two glass-edge mounting feet
• Glass-protection components
• Model-specific screws and assembly parts

Light-specific suspension cables may be sold separately.

Installation

1. Disconnect the light from power.
2. Confirm aquarium-glass thickness and compatibility.
3. Inspect and clean the rear-glass mounting areas.
4. Assemble both stands according to the instructions.
5. Position the protective components between the metal clamps and glass.
6. Attach the first stand without overtightening.
7. Install the second stand according to the light’s suspension points.
8. Confirm that both stands are vertical and positioned equally.
9. Attach the correct suspension cables to the light.
10. Suspend the light from two points.
11. Adjust and level the light.
12. Confirm that every clamp, screw, and cable lock is secure.
13. Route the power cable without placing tension on the light.
14. Create a drip loop.
15. Inspect all mounting components regularly.