Chihiros A-sarja/A+ sarja -ruostumaton teräs teline

The stainless-steel stand replaces the standard supports of a compatible Chihiros A or A Plus Series LED light. Raising the light creates additional room for plant trimming, aquarium maintenance, and emergent growth.

The increased mounting height also broadens light distribution across the aquarium. This can provide more even coverage in wide or shallow planted tanks, although the intensity reaching the substrate may decrease as the mounting height increases.

Key features

• Stainless-steel stand for Chihiros LED lights
• Designed for compatible A and A Plus Series models
• Raises the light above the aquarium
• Broadens light distribution
• Improves maintenance access
• Suitable for open aquariums
• Suitable for planted and aquascaping aquariums
• Stainless-steel support arms
• Transparent acrylic holders
• Approximate height: 22 cm
• Approximate horizontal-arm length: 11 cm
• Can help adapt the installation width
• Complete mounting set for one light
• LED light and aquarium sold separately

Technical information

• Product type: elevated LED-light stand
• Compatibility: Chihiros A Series and selected A Plus models
• Materials: stainless steel and acrylic
• Approximate height: 22 cm
• Approximate arm length: 11 cm
• Stainless-steel arms: 4
• Acrylic holders: 2

Installation

1. Disconnect the light from power.
2. Remove its original supports.
3. Place the light on a clean, protected surface.
4. Assemble the steel arms and acrylic holders.
5. Install one assembled stand at each end of the light.
6. Tighten the screws evenly without overtightening.
7. Position the light carefully above the aquarium.
8. Adjust both stands symmetrically.
9. Check that the light is level and stable.
10. Route the power cable without tension.
11. Create a drip loop.
12. Inspect the screws and acrylic components regularly.